SSTC help
|
|
sparky99
|
Wed Sept 29 2010, 12:44AM
|
|
|
Registered Member #1159
Joined: Fri Dec 07 2007, 02:10AM
Location: Hudson Valley of NY State
Posts: 84
|
Picked up a SSTC done by Jeff Messer (JM Labs) at a recent hamfest. Missing the handheld controller. Guy said it was just a switch and a pot. He had the instruction flyer & a glance revealed a schematic......except it wasn't a complete schematic. No controller wiring.
The guy said he bought it off eBay about 3 years ago. I couldn't find much online. The controller is fed with a 3 wire 1/8" plug with tip, ring & sleeve. Anyone Have any ideas how to figure out the switch / pot wiring? The common shouldn't be too hard to figure out. I could tear into it & reverse engineer the board, but I'd rather not do that unless I have no other options.
Thanks, Bob Arenella
|
Back to top
|
|
dmg
|
Wed Sept 29 2010, 01:00AM
|
|
|
Registered Member #2628
Joined: Fri Jan 15 2010, 12:23AM
Location:
Posts: 627
|
Do you have any pictures of this?
|
Back to top
|
|
sparky99
|
Thu Sept 30 2010, 04:19PM
|
|
|
Registered Member #1159
Joined: Fri Dec 07 2007, 02:10AM
Location: Hudson Valley of NY State
Posts: 84
|
Here's a few pictures of the coil.
bob
|
Back to top
|
|
Moderator(s): Chris Russell, Noelle, Alex, Tesladownunder, Dave Marshall, Dave Billington, Bjørn, Steve Conner, Wolfram, Kizmo, Mads Barnkob
|
|
Powered by e107 Forum System
|