Little Dragon Tesla Coil is now pushing 6 inches!
|
|
SparkLabs
|
Fri Oct 30 2009, 03:23AM
|
|
|
Registered Member #2418
Joined: Mon Oct 05 2009, 12:24AM
Location: Indianapolis, Indiana U.S.A.
Posts: 11
|
I have completed the final circuit of my tesla coil and it works quite well! The tesla coil is meeting my requirements, and I am not destroying components like in the earlier prototype... BUT that was until I had a mishap with the full bridge when I reconfigured the interruptor to output shorter pulses. I connected a resistor in the wrong place in the interruptor and when I turned on the tesla coil, I heard a pop and half of my bridge shorted out. Ooops! I replaced the components and tried again and here is what I got!
Now the next step is to box this Tesla coil and mount the controls and I should be ready to go! This includes soldering the entire driver circuit to a PC board.
]1029092244a.avi[/file]


|
Back to top
|
|
Moderator(s): Chris Russell, Noelle, Alex, Tesladownunder, Dave Marshall, Dave Billington, Bjørn, Steve Conner, Wolfram, Kizmo, Mads Barnkob
|
|
Powered by e107 Forum System
|