My ferrite core SMPS
|
|
rp181
|
|
Registered Member #1062
Joined: Tue Oct 16 2007, 02:01AM
Location:
Posts: 1529
|
I am winding a new secondary after i ran out off wire on the other. On this one, i epoxied the acrylic together (rather than tape) so i could use it under oil. I am winding the secondary in two sections, of about 80 turns each, for a total of 160. On the primary side, I was planning to use 330v with 10 turns, for 33 v/turn. I think this core can handle more (based on finn's measurements), so i think i could go a 5 turn primary. That gives me a output of 5kV a section, for 10kV total. After the harmonics doubling, that gives me 20kV. Anyone see any flaw in my logic?
|
Back to top
|
|
Moderator(s): Chris Russell, Noelle, Alex, Tesladownunder, Dave Marshall, Dave Billington, Bjørn, Steve Conner, Wolfram, Kizmo, Mads Barnkob
|
|
Powered by e107 Forum System
|