- Posted by Uspring on Thursday 08 August 2013 - 10:05:41
...lue shows therefore only that part going into the toroid capacitance. It is thus proportional to the top voltage. The measured arc current is shown in...
- Posted by Uspring on Thursday 08 August 2013 - 10:05:41
...arge amount just before they break out due to the toroid at which point they fall drastically and then start growing again, but at a slower rate. The ...
- Posted by Uspring on Thursday 08 August 2013 - 10:05:41
...rst cycle has enough energy to break out from the toroid immediately, where a QCW needs 10’s to 100’s of cycles to get to the same level...
- Posted by Avalanche on Sunday 04 August 2013 - 16:45:02
...m
2600 Turns (winding length 650mm)
Fres with Toroid = 84kHz
Primary L = 16.8uH
Secondary L = 166.8mH
Mutual L = 665.1uH
Coupling K = 0.39...
- Posted by Avalanche on Sunday 04 August 2013 - 16:45:02
...2600 Turns (0.25mm wire)
fRes = 82.65kHz (with toroid)
Total Topload Capacitance (Ctop): 18.55713 pF
Primary Inductance (L1): 31.06074 uH
Sec...
- Posted by Avalanche on Sunday 04 August 2013 - 16:45:02
...ng for a resonant frequency of <120kHz without toroid, and hoping for 6-7' of spark. I'll put some proper specs up when I've spent a couple more lu...
- Posted by Blitz on Tuesday 16 July 2013 - 02:16:36
...WG wound on a 2.5x7 inch PVC tube. 1125 turns.
Toroid: 6 in major/ 1.5 inch minor. Fres of secondary with the toroid is ~370kHz
Primary: 5.1 tur...
- Posted by tarakan2 on Saturday 13 July 2013 - 18:56:46
...
- Posted by brtaman on Wednesday 10 July 2013 - 17:08:52
...oven design.
Here is a photo of the form and toroid, with the 30AWG wire ready for winding. While it might not look it...that toroid took a very ...
- Posted by the mad scientist on Wednesday 03 July 2013 - 22:22:25
...nce between the bottom of your secondary and your toroid. Tell us the value measured.
- try putting a break out point on your toroid and see if i...
