Low inductance full bridge layout.
|
|
Jorrit
|
Sat Sept 09 2006, 01:32PM
|
|
|
Registered Member #140
Joined: Sat Feb 11 2006, 11:43AM
Location: The Netherlands
Posts: 14
|
@ Steve Ward. Thanks. The secondary dimensions are: 25cm width and 110 cm high. There are about 2100 turns of 0.5 mm wire.
Went to the shop today to buy some copper clad but the prices had doubled. So the copper clad would cost me 60 euro. So instead of 1.5 mm copper clad I went for 3 mm alluminium which only costed me 5 euro. I know copper is a better conductor but I hope 3 mm alluminium will be enough.
|
Back to top
|
|
Moderator(s): Chris Russell, Noelle, Alex, Tesladownunder, Dave Marshall, Dave Billington, Bjørn, Steve Conner, Wolfram, Kizmo, Mads Barnkob
|
|
Powered by e107 Forum System
|