Beware of cheap epoxy resin glue
|
|
Dr. Drone
|
|
Registered Member #290
Joined: Mon Mar 06 2006, 08:24PM
Location:
Posts: 1673
|
Good day,
I am just curious, did you try sticking a ohm meter probes into the epoxy before it is cured?
I use this to find out if I will have issues, but maybe it became conductive after it cured which means my idea is no longer valid..
Rgs, Ch_r
|
Back to top
|
|
Sulaiman
|
|
Registered Member #162
Joined: Mon Feb 13 2006, 10:25AM
Location: United Kingdom
Posts: 3140
|
No I didn't - I never expected a problem based on experience with 'Araldite' epoxy resin I suppose a test batch of epoxy resin would have been smart but once poured over the MMC it's too late anyway.
|
Back to top
|
|
Fusion
|
|
Registered Member #354
Joined: Thu Mar 30 2006, 10:12AM
Location:
Posts: 55
|
I am looking for a hard and isolator glue that do not reduce its mass after curing. In my company epoxi is used, but it may be a lot expensive. I where looking for ceramics but I would have to heat to 1100ºC. Did anybody tested epoxi resin that usually is used with fiber glass?
|
Back to top
|
|
Moderator(s): Chris Russell, Noelle, Alex, Tesladownunder, Dave Marshall, Dave Billington, Bjørn, Steve Conner, Wolfram, Kizmo, Mads Barnkob
|
|
Powered by e107 Forum System
|